Installing and putting a TIM into operation
4.6 Configuring a TIM and setting parameters
Station control system
168 System Manual, 07/2009, C79000-G8976-C178-07
6,1$8767
KDUGZDUHFDWDORJLQ
IROGHU6,0$7,&
Figure 4-29 The catalog window
Hardware Catalog
with the SINAUT ST7 folder open
You can select the TIM you want to install in a rack from this catalog. The following figure
shows an S7-300 station with a TIM and various other modules installed.
Assigning parameters to the TIM
If you double-click on the TIM module, you open the parameter assignment dialog for the
TIM. You can then specify the required properties in a series of tabs.
To Next Page
Loading...
