Installing and putting a TIM into operation
4.6 Configuring a TIM and setting parameters
Station control system
System Manual, 07/2009, C79000-G8976-C178-07
169
Figure 4-30 S7-300 station with installed TIM and TIM parameter assignment dialog
Setting parameters for networks and network nodes
The next step is to connect the various stations in a WAN. This part of the configuration is
done with the
NetPro
STEP 7 program.
If you are using an IP-based WAN such as DSL or GPRS, take a normal Industrial Ethernet
from the NetPro catalog. The classic SINAUT WANs "dedicated line" and "dial-up network"
can also be taken from the NetPro catalog. These SINAUT networks have been added to the
"Subnets" folder.
To Next Page
Loading...
