Siemens SINUMERIK 808D - Page 152

As soon as the path axes have been traversed (not with G00, always with G63), the tool
time monitoring data of the active D compensation are updated for the tool in the
selected tool holder, which is also the master tool holder.
Bit 0...x-1: Monitoring of the tool in tool holder 1...x
20360 TOOL_PARAMETER_DEF_MASK C09 M5, P1, W1
- Definition of tool parameters DWORD PowerOn
-
808d-me42 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x3FFFFF 1/1 M
808d-me62 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x3FFFFF 1/1 M
808d-te42 - 0x283 0 0x3FFFFF 1/1 M
808d-te62 - 0x283 0 0x3FFFFF 1/1 M
808d-mte40 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x3FFFFF 1/1 M
808d-mte60 - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x3FFFFF 1/1 M
Description: Definition of the effects of tool parameters.
Bit no. meaning when bit is set
-----------------------------------------------------------------------------
Bit 0: (LSB):
For turning and grinding tools, the wear parameter of the transverse axis is included
in the calculation as a diameter value.
Bit 1:
For turning and grinding tools, the tool length component of the transverse axis is
included in the calculation as a diameter value.
Bit 2:
If a tool length correction is included in the calculation as a diameter value, the
tool
may
only
be used in the plane that was active when the tool was selected. If this
bit is set, a plane change leads to an alarm.
Bit 3:
Work offsets in frames in the transverse axis are included in the calculation as
diameter values.
Bit 4:
PRESET value is included in the calculation as a diameter value
Bit 5:
Include the external work offset in the transverse axis in the calculation as a
diameter value
Bit 6:
Read actual values of the transverse axis as diameter values (AA_IW, AA_IEN, AA_IBN,
AA_IB. Notice: Not AA_IM.)
Bit 7:
Display all actual values of the transverse axis as diameter values, irrespective of
the G code of group 29 (DIAMON / DIAMOF)
Bit 8:
Always display the distance-to-go as a radius in the work coordinate system (Work)
Bit 9:
During DRF handwheel travel of a transverse axis, only half the distance of the
specified
increment is
traveled (on condition that MD11346 $MN_HANDWH_TRUE_DISTANCE =
1).
Bit10:
Machine data
3.3 Channel-specific machine data
Parameter Manual
152 List Manual, 01/2017