Activate the tool component of an active, orientable tool holder even if no tool is
active.
Bit11:
The tool parameter $TC_DP6 is not interpreted as a tool radius but as a tool diameter.
Bit12:
The tool parameter $TC_DP15 is not interpreted as wear of the tool radius but as wear
of the tool diameter.
Bit13:
During JOG of circles, the circle center coordinate is always a radius value, see
D42690 $SC_JOG_CIRCLE_CENTRE.
Bit14:
Absolute values of the transverse axis with cycle masks in the radius
Bit15:
Incremental values of the transverse axis with cycle masks as diameter
Bit16:
For GWPS (GWPSON/TMON), the tool parameters, tool length, wear and base dimension, are
interpreted as diameter values
Bit17:
With cutting edge position compensation (CUTMOD) for turning and grinding tools, the
cutting plane for calculating the compensation values is rotated into the machining
plane.
If this
bit is not set, the cutting edge is projected into the machining plane
instead.
Bit18:
With cutting edge position compensation (CUTMOD) for turning and grinding tools,
always use the active plane (G17 - G19). If this bit is not set, the plane specified
by
setting data
SD42940 $SC_TOOL_LENGTH_CONST has priority over the plane specified by
the G code group 6 (plane selection, G17 - G19).
Bit19:
The tool orientation change caused by an orientable tool holder becomes effective even
if no tool is active. This bit is only effective if bit 10 is also set.
Bit20:
If this bit is zero, and if the tool parameter $TC_DP10 (holder angle) and/or $TC_DP24
(clearance angle) contain the value 0, the following default values are used as the
basis
for the
function CUTMOD to calculate the modified cutting-edge position and the
modified cutting-edge direction:
Holder angle 112.5 degrees for cutting-edge positions 1 - 4
Holder angle 67.5 degrees for cutting-edge positions 5 - 8
Clearance angle 22.5 degrees for cutting edge positions 1 - 4
Clearance angle 67.5 degrees for cutting-edge positions 5 - 8
If this bit is set, an alarm is output in the cases mentioned. This bit is used to
establish compatibility with older software releases.
Bit21:
If this bit is zero, any existing rotation in the part proportion of the tool carrier
is taken into account for CUTMOD with tool carrier when modifying the cutting edge
position. Frames are ignored.
If this bit is 1, in the place of the part proportion of the tool carrier, the
active total frame is taken into account with CUTMOD with tool carrier with
modification of the cutting edge position. The total frame can also contain a part
proportion of the tool carrier.
Machine data
3.3 Channel-specific machine data
Parameter Manual
List Manual, 01/2017 153
To Next Page
Loading...
