Siemens SINUMERIK 808D - Page 154

20370 SHAPED_TOOL_TYPE_NO C01, C08 -
- Tool type number for contour tools DWORD Immediately
-
808d-me42 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 7/2 M
808d-me62 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 7/2 M
808d-te42 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 7/2 M
808d-te62 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 7/2 M
808d-mte40 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 0/0 S
808d-mte60 4 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
- - 0/0 S
Description: Indicates for each channel max. two number ranges for tool types that are treated as
forming tools. Therefore individual ranges are possible both for grinding and for
turning tools.
The first range is specified by the first and the second number, the second range by
the third and fourth number.
If the first number is not smaller than the second one (the same applies for the third
and fourth number), no range will be defined, but two individual numbers will be
specified instead.
The numbers 400 through 599 are permissible (tool type numbers for turning and
grinding tools), and also value 0 (no tool type number defined).
Examples:
400 405 590 596 : Tool types 400-405 and 590-596 are contour tools
410 400 590 596 : tool types 400, 410 and 590-596 are contour tools
450 0 420 430 : Tool types 450 and 420-430 are contour tools
20372 SHAPED_TOOL_CHECKSUM C01, C08 -
- Checksum test for contour tools BOOLEAN Immediately
-
808d-me42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/5 U
808d-me62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/5 U
808d-te42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/5 U
Machine data
3.3 Channel-specific machine data
Parameter Manual
154 List Manual, 01/2017