808d-te62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/5 U
808d-mte40 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-mte60 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
Description: Indicates for each channel whether for completion of the contour tool definition an
edge must be available that includes the negative sums of tool length components and
tool radius of the previous edges.
20380 TOOL_CORR_MODE_G43G44 C01, C08, C11 -
- Treatment of tool length compensation with G43 / G44 BYTE Reset
-
808d-me42 - 1 0 2 2/2 M
808d-me62 - 1 0 2 2/2 M
808d-te42 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2 M
808d-te62 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2 M
808d-mte40 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2 M
808d-mte60 - 0, 0, 0, 0, 0, 0, 0, 0... 0 2 2/2 M
Description: This machine data determines in ISO mode M (G43 / G44) the way in which length
compensations programmed with H are processed.
0: Mode A
Tool length H always acts on the third geometry axis (usually Z)
1: Mode B
Tool length H acts, depending on the active plane, on one of the three geometry axes.
This means with
G17 on the 3rd geometry axis (usually Z)
G18 on the 2nd geometry axis (usually Y)
G19 on the 1st geometry axis (usually X)
In this mode, compensations in all three geometry axes can be configured through
multiple programming, i.e. through the activation of one component, the length
compensation possibly active in another axis is not deleted.
2: Mode C
The tool length acts, irrespective of the active plane, on the axis that has
simultaneously been programmed with H. Otherwise, the response is the same as with
mode B.
20382 TOOL_CORR_MOVE_MODE C01, C08 -
- Traversing of tool length compensation BOOLEAN Reset
-
- - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 1/1 M
Description: This machine data determines how the tool length compensations are traversed.
0: A tool length compensation is only traversed if the associated axis has been
programmed (behavior as in previous software versions)
Machine data
3.3 Channel-specific machine data
Parameter Manual
List Manual, 01/2017 155
To Next Page
Loading...
