Siemens SINUMERIK 808D - Page 156

1: Tool lengths are always traversed independently of whether the associated axes
are programmed or not.
20384 TOOL_CORR_MULTIPLE_AXES C01, C08, C11 -
- Tool length compensation in several axes simultaneously BOOLEAN Reset
-
- - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 1/1 M
Description: This machine data determines for tool length compensation in ISO mode M (ISO2) (G43 /
G44), whether the compensation shall be allowed in mode C (selection of the axis on
which the compensation is acting by specifying the corresponding axis letter) to act
on several axes simultaneously.
If this machine data is 1, this type of programming is allowed; otherwise it is
rejected with an alarm.
20390 TOOL_TEMP_COMP_ON C01, C08 K3, W1
- Activation of temperature compensation for tool length BOOLEAN Reset
-
808d-me42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
808d-me62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
808d-te42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
808d-te62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
808d-mte40 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-mte60 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
Description: This machine data activates the temperature compensation in tool direction (see also
SD42960 $SC_TOOL_TEMP_COMP)
20392 TOOL_TEMP_COMP_LIMIT C01, C08 W1
mm Max. temperature compensation for tool length DOUBLE Reset
-
808d-me42 3 1.0, 1.0 , 1.0, 1.0, 1.0 ,
1.0, 1.0, 1.0 , 1.0, 1.0,
1.0 , 1.0, ...
0.0 - 7/7 U
808d-me62 3 1.0, 1.0 , 1.0, 1.0, 1.0 ,
1.0, 1.0, 1.0 , 1.0, 1.0,
1.0 , 1.0, ...
0.0 - 7/7 U
Machine data
3.3 Channel-specific machine data
Parameter Manual
156 List Manual, 01/2017