Siemens SINUMERIK 808D

The rapid traverse feedrate must be entered in SD42160
$SC_EXTERN_FIXED_FEEDRATE_F1_F9[0].
42162 EXTERN_DOUBLE_TURRET_DIST - FBFA
- Double turret head tool distance DOUBLE Immediately
-
- - 0., 0., 0., 0., 0., 0., 0.,
0....
0.0 - 7/7 U
Description: Distance between both tools of a double turret head.
42200 SINGLEBLOCK2_STOPRE - BA
- Activate SBL2 debug mode BOOLEAN Immediately
-
- - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/7 U
Description: Value = TRUE:
A preprocessing stop is made with every block if SBL2 (single block with stop after
every
block) is
active. This suppresses the premachining of part program blocks. This
variant of the SBL2 is not true-to-contour.
This means that a different contour characteristic might be generated as a result of
the preprocessing stop than without single block or with SBL1.
Application: Debug mode for testing part programs.
42440 FRAME_OFFSET_INCR_PROG - K1, K2
- Work offsets in frames BOOLEAN Immediately
-
808d-me42 - FALSE 0 - 2/2 M
808d-me62 - FALSE 0 - 2/2 M
808d-te42 - FALSE 0 - 2/2 M
808d-te62 - FALSE 0 - 2/2 M
808d-mte40 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
808d-mte60 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
Description: 0: When incremental programming is used on an axis, only the programmed position
delta is traversed
after a frame change. Work offsets in FRAMES are only traversed when
an absolute position is specified.
1: When incremental programming is used on an axis, changes to work offsets are
traversed after a frame change (standard response up to software version 3).
Related to ....
SD42442 $SC_TOOL_OFFSET_INCR_PROG
42442 TOOL_OFFSET_INCR_PROG - W1, K1
- Tool length compensations BOOLEAN Immediately
-
808d-me42 - FALSE 0 - 2/2 M
808d-me62 - FALSE 0 - 2/2 M
808d-te42 - FALSE 0 - 2/2 M
NC setting data
Parameter Manual
List Manual, 01/2017 333