Siemens SINUMERIK 808D

808d-te62 - FALSE 0 - 2/2 M
808d-mte40 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
808d-mte60 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
Description: 0: When incremental programming is used on an axis, only the programmed position
delta is traversed after a frame change. Tool length offsets in FRAMES are only
traversed when an absolute position is specified.
1: When incremental programming is used on an axis, changes to tool length offsets
are traversed after a tool change (standard response up to SW version 3).
Related to ....
SD42440 $SC_FRAME_OFFSET_INCR_PROG
42444 TARGET_BLOCK_INCR_PROG - BA
- Set down mode after search run with calculation BOOLEAN Immediately
-
808d-me42 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-me62 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-te42 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-te62 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-mte40 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
808d-mte60 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
Description: If the first programming of an axis after "Search run with calculation to end of block"
is incremental, the incremental value is added as a function of SD42444
$SC_TARGET_BLOCK_INCR_PROG to the value accumulated up to the search target :
SD = TRUE: Incremental value is added to accumulated position
SD = FALSE: Incremental value is added to current actual value
The setting data is evaluated on NC start for output of the action blocks.
42450 CONTPREC - B1, K6
mm Contour accuracy DOUBLE Immediately
-
808d-me42 - 0.1, 0.1, 0.1, 0.1, 0.1,
0.1, 0.1, 0.1...
0.000001 999999. 0/0 S
808d-me62 - 0.1, 0.1, 0.1, 0.1, 0.1,
0.1, 0.1, 0.1...
0.000001 999999. 0/0 S
808d-te42 - 0.1, 0.1, 0.1, 0.1, 0.1,
0.1, 0.1, 0.1...
0.000001 999999. 0/0 S
808d-te62 - 0.1, 0.1, 0.1, 0.1, 0.1,
0.1, 0.1, 0.1...
0.000001 999999. 0/0 S
NC setting data
Parameter Manual
334 List Manual, 01/2017