Siemens SINUMERIK 808D Parameter Manual

2 | 1: Approach end position after sparking out
------------------------------------------------------------------------------
3 | 1: If the oscillating movement is canceled by delete distance-to-go,
| then the sparking-out strokes are to be executed afterwards
| and the end position approached if necessary
------------------------------------------------------------------------------
4 | 1: If the oscillating movement is canceled by delete distance-to-go,
| then the corresponding reversal point
| is approached on switch off
------------------------------------------------------------------------------
5 | 1: Changed feedrate does not become active until the next reversal point
------------------------------------------------------------------------------
6 | 1: Path override is active if the feed rate is 0,
| otherwise speed override is active
------------------------------------------------------------------------------
7 | 1: In the case of rotary axes DC (shortest path)
------------------------------------------------------------------------------
8 | 1: Execute sparking-out stroke as single stroke not as double stroke
------------------------------------------------------------------------------
9 | 1: On starting, first approach the starting position, see
| SD43790 $SA_OSCILL_START_POS
------------------------------------------------------------------------------
Application example(s)
NC language: OSCTRL[Axis]=(setting options, reset options)
Related to ....
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
43780 OSCILL_IS_ACTIVE - P5
- Activate oscillation movement BOOLEAN Immediately
-
808d-me42 - FALSE 0 - 7/7 U
808d-me62 - FALSE 0 - 7/7 U
808d-te42 - FALSE 0 - 0/0 S
808d-te62 - FALSE 0 - 0/0 S
808d-mte40 - FALSE 0 - 7/7 U
808d-mte60 - FALSE 0 - 7/7 U
Description: Switching the oscillating movement on and off
Note:
MD 10710 $MN_PROG_SD_RESET_SAVE_TAB can be be set so that the value written by the part
program is transferred to the active file system on reset (that is the value is
retained after reset.)
Application example(s)
NC language: OS[Axis]=1, OS[Axis]=0
Related to ....
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
NC setting data
Parameter Manual
List Manual, 01/2017 371

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English