Siemens SINUMERIK 808D Parameter Manual

Only G codes can be reconfigured, e.g.: G20, G71.
10884 EXTERN_FLOATINGPOINT_PROG N12 FBFA
- Evaluation of programmed values without decimal point BOOLEAN PowerOn
-
- - TRUE 0 - 2/2 M
Description: This MD defines how programmed values without a decimal point are evaluated:
0: 'Standard notation', values without a decimal point are interpreted in internal
units. For example, X1000 = 1 mm (for 0.001 mm input resolution) X1000.0 = 1000 mm
1: 'Pocket calculator notation', values without a decimal point are interpreted as mm,
inches or degrees. For example, X1000 = 1000 mm X1000.0 = 1000 mm
Related to:
MD10886 $MN_EXTERN_INCREMENT_SYSTEM
10886 EXTERN_INCREMENT_SYSTEM N12 FBFA
- Incremental system in external language mode BOOLEAN PowerOn
-
- - FALSE 0 - 2/2 M
Description: This machine data is active for external programming languages,
This machine data specifies which incremental system is active:
0: Incremental system IS-B = 0.001 mm/degree
= 0.0001 inch
1: Incremental system IS-C = 0.0001 mm/degree
= 0.00001 inch
Related to:
MD10884 $MN_EXTERN_FLOATINGPOINT_PROG
10888 EXTERN_DIGITS_TOOL_NO N12 FBFA
- Digits for T number in ISO mode BYTE PowerOn
-
- - 2 0 8 2/2 M
Description: This machine data is only active when MD10880 $MN_MM_EXTERN_CNC_SYSTEM == 2.
Number of digits of the tool number in the programmed T word.
From the programmed T word, the number of leading digits specified in MD10888
$MN_EXTERN_DIGITS_TOOL_NO are interpreted as the tool number.
The following digits address the offset memory.
Entering a value > 0 in MD10889 $MN_EXTERN_DIGITS_OFFSET_NO renders MD10888
$MN_EXTERN_DIGITS_TOOL_NO ineffective.
MD10889 $MN_EXTERN_DIGITS_OFFSET_NO has priority over MD10888
$MN_EXTERN_DIGITS_TOOL_NO.
10889 EXTERN_DIGITS_OFFSET_NO N12 FBFA
- Digits for offset number in ISO mode BYTE PowerOn
-
- - 0 0 8 2/2 M
Description: This machine data is only active when MD10880 $MN_MM_EXTERN_CNC_SYSTEM == 2.
Number of digits of the offset number in the programmed T word.
From the programmed T word, the number of leading digits specified in MD10889
$MN_EXTERN_DIGITS_OFFSET_NO are interpreted as the offset number.
The following digits address the tool number.
Machine data
3.2 General machine data
Parameter Manual
List Manual, 01/2017 55

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English