Siemens SINUMERIK 810D Operation/Programming

2
Operation 10.04
2.10 Automatic mode
2
 Siemens AG, 2004. All rights reserved
2-124 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Specify target directly
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Search
pointer
 Press the "Block search" and "Search pointer" softkeys.
 Specify the desired target.
To
endpoint
...
External -
without cal.
 Select a calculation technique.
Cycle Start
 Press the "Cycle Start" key.
ShopMill carries out all necessary default settings.
Cycle Start
 Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
Reset
You can abort the search by pressing the "Reset" key.
Search for any text
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Search
 Press the "Block search" and "Search" softkeys.
 Enter the text string that you want to locate.
 Select whether the search is to commence at the start of the
program or the current cursor position.
Search
 Press the "Search" softkey.
The program block that contains the text string is marked.
Continue
search
 Press the "Continue search" softkey, if you want to continue the
search.
Start
search run
 Press the "Abort" and "Start search run" softkeys.
 Where chained program blocks have several technology blocks,
select the desired technology block in the "Search run" window
and press the "Accept" softkey.
The prompt does not appear in the case of single program blocks.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English