Siemens SINUMERIK 810D Operation/Programming

8
10.04 Alarms and Messages
8.2
A
larms in Sho
p
Mill
8
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition 8-409
112325
Replace swivel head
Explanation The operator is prompted to replace the specified swivel head in the
spindle with the new swivel head.
Response Alarm display
Please refer to the machine manufacturer's instructions.
Remedy Exchange swivel head.
Please refer to the machine manufacturer's instructions.
112326
Set swivel head
Explanation The operator is prompted to set the swivel head in accordance with
the specified data.
Response Alarm display
Please refer to the machine manufacturer's instructions.
Remedy Set swivel head.
Please refer to the machine manufacturer's instructions.
112327
Angle outside the permissible range
Explanation The programmed machining operation cannot be performed with the
inclinable head.
Response Alarm display
Remedy Perform NC reset.
Clamp the workpiece differently if appropriate.
112328
Angle adapted to angle grid
Explanation Due to the angle grid, the swivel head could not be set exactly to the
specified angle.
Response Alarm display
Remedy Machining can be continued with the specified values, but it will not
correspond exactly to the programming.
112329
Set swivel head/table
Explanation The operator is prompted to set the swivel head/table in accordance
with the specified data.
Response Alarm display
Please refer to the machine manufacturer's instructions.
Remedy Set swivel head/table.
Please refer to the machine manufacturer's instructions.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English