Siemens SINUMERIK 810D Operation/Programming

8
Alarms and Messages 10.04
8.2 Alarms in Sho
p
Mill
8
 Siemens AG, 2004. All rights reserved
8-410 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
112330
Set swivel table
Explanation The operator is prompted to set the swivel table in accordance with
the specified data.
Response Alarm display
Please refer to the machine manufacturer's instructions.
Remedy Set swivel table.
Please refer to the machine manufacturer's instructions.
112340
Confirmation not possible because axes are not referenced!
Explanation User confirmation in Safety Integrated cannot be given until the
reference point has been approached.
Response Alarm display
Remedy Approach reference point.
112350
No swiveling data available
Explanation No swiveling data sets are available.
Response Alarm display
Remedy Set up the necessary swiveling data sets
(see /FBSP/, ShopMill Description of Functions)
112360
Step was not included in program chain because program is
running
Explanation The program that you want to change is currently being executed in
"Machine Auto" mode. You cannot change programs when they are
being executed in "Machine Auto" mode.
Response Alarm display
Remedy End program execution in "Machine Auto" mode.
112400
Does not exist in tool management
Explanation The tool specified in the program does not exist.
Response Alarm display
Remedy The tool must be created before the data backup.
112401
Could not create tool
Explanation A tool could not be created when reading in tool data.
Response Alarm display
Remedy Check the tool management system.
112402
Work offsets: Error when writing
Explanation Data was not written into the work offset.
Response Alarm display
Remedy Check work offset.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English