4
03.04 Machine Operating Area
4.1 Data structure of the NC control
4
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 4-101
Other information
The basic display of the selected mode appears on the screen.
If a mode change is not possible, please contact your installation
engineer, the machine-tool manufacturer or our service personnel.
In many cases, a mode change is enabled only for trained personnel
for the purpose of safety. To provide this type of protection, the control
system offers a facility for disabling or enabling mode changes.
/FB/, K1, Description of Functions
To Next Page
Loading...
Need help?
General
