5
03.04 "Parameters" Operating Area
5.3 Tool mana
ement
5
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 5-217
Abort
The tool is not relocated.
Start
The tool is relocated to the new empty location.
Use magazine number 9998 to move a tool to or from a spindle
location.
When relocating from the buffer, the previous location information is
entered by default. This applies to fixed-location-coded and variable
tools.
5.3.8 Tool master data in the tool catalog
Function
You can create tool master data in the tool catalog. A set of data can
be created for every tool in use.
Advantage Master data which apply to the tool, regardless of which cutting edge
you use, do not have to be entered again for every new tool you
create, but can be copied from the tool catalog (in the tool cabinet) for
each tool you use.
Ideal tools
The tool catalog contains only "ideal" tools.
"Ideal" tools are characterized by the relevant tool "master data" (i.e.
with ideal tool dimensions, no wear, etc.). An "ideal" tool is uniquely
defined by its "Tool name".
To Next Page
Loading...
Need help?
General
