Siemens SINUMERIK 810D User Manual

2
Operator Components/Sequence of Operations 03.04
2.6 General se
q
uence of o
p
eration
2
Ó Siemens AG, 2004. All rights reserved
2-54 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2.6 General sequence of operation
Keys
A range of keys and menus is provided in the various operating areas.
The function of the keys and menus is the same in all operating areas.
This identical functionality applies only if the operating areas are left
intact as supplied by Siemens AG and no modifications have been
configured by the user.
Other Information
In SW 6.3 and higher, it is possible to customize the menu trees.
Users can create and define softkeys to meet their individual needs.
Due to this capability, the menus and softkeys on your control may be
different to those described in this Operator's Guide.
/IAM/, IM4 Chapter 5 Functions/Parameters, see
User-specific operator trees
Functions
The following section describes functions which you can select in
several operating modes.
2.6.1 Program overview and program selection
Function
After selection of a workpiece or program overview, individual
workpieces or programs can be enabled or disabled for execution.
Operating sequence
"AUTO" mode is selected in the "Machine" operating area.
The appropriate channel is selected.
The channel is in reset state.
The workpiece/program to be selected is in the memory.
An overview of all workpiece directories/programs that exist is
displayed.
Position the cursor on the desired workpiece/program.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English