4
Machine Operating Area 03.04
4.3 Reference
oint a
roach
4
Ó Siemens AG, 2004. All rights reserved
4-118 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Machine manufacturer
Your machine manufacturer will instruct you how to select axes if you
intend to enter more than nine.
Other information
The sequence in which axes must be referenced can be defined by
the machine-tool manufacturer.
The NC cannot be started in automatic mode until all axes with a
defined reference point (see machine data MD) have actually reached
this point.
To Next Page
Loading...
Need help?
General
