Siemens SINUMERIK 810D - Page 14

0
Contents 03.04
0
Ó Siemens AG, 2004. All rights reserved
xiv SINUMERIK 840D/840Di/810D Operator’s Guide HMI Advanced (BAD) – 03.04 Edition
2.8.1 Syntax description for job lists................................................................................... 2-80
2.8.2 Example of a job list with two-channel 1:1 connections ............................................2-83
2.8.3 Example of a job list with multi-channel m:n connections .........................................2-84
2.8.4 "Execute job list" operating sequence .......................................................................2-85
2.8.5 Rename workpieces with job lists .............................................................................2-87
2.8.6 Copy workpieces with job lists................................................................................... 2-88
2.8.7 Archive workpieces with job lists in case of m:n........................................................2-88
Example of Operation 3-89
3.1 Typical sequence of operation................................................................................... 3-89
Machine Operating Area 4-91
4.1 Data structure of the NC control................................................................................ 4-93
4.1.1 Operating modes and machine functions..................................................................4-94
4.1.2 Mode groups and channels ....................................................................................... 4-96
4.1.3 Channel-wide status display with symbols (SW 6.2 and higher)...............................4-97
4.1.4 Dual-channel display (SW 6.4 and higher)................................................................ 4-98
4.1.5 Operating mode selection/change............................................................................. 4-99
4.2 General functions and displays ............................................................................... 4-102
4.2.1 Stop/start/cancel/continue part program .................................................................4-102
4.2.2 Display program level .............................................................................................. 4-103
4.2.3 Toggling between Machine/Work (MCS/WCS)....................................................... 4-104
4.2.4 Display axis feeds....................................................................................................4-106
4.2.5 Display G functions, transformations and swivel data.............................................4-106
4.2.6 Display auxiliary functions .......................................................................................4-107
4.2.7 Display spindles.......................................................................................................4-108
4.2.8 Handwheel............................................................................................................... 4-109
4.2.9 Status of synchronized actions................................................................................ 4-110
4.2.10 Preset ......................................................................................................................4-112
4.2.11 Setting the actual value ...........................................................................................4-113
4.2.12 Inch/metric switchover............................................................................................. 4-114
4.3 Reference point approach ....................................................................................... 4-116
4.4 JOG mode ............................................................................................................... 4-119
4.4.1 Function and main screen .......................................................................................4-119
4.4.2 Traverse the axes.................................................................................................... 4-122
4.4.3 Inc: Incremental dimensions....................................................................................4-123
4.4.4 Repos (repositioning) .............................................................................................. 4-124
4.4.5 SI (Safety Integrated): User agreement ..................................................................4-125
4.4.6 Scratching (SW 6 or higher) .................................................................................... 4-126
4.4.7 Scratching (SW 5 and lower)...................................................................................4-130
4.4.8 Display system frames ............................................................................................4-133
4.5 MDI mode................................................................................................................4-135
4.5.1 Function and main screen .......................................................................................4-135
4.5.2 Save program, file function...................................................................................... 4-137
4.5.3 Teach-in ..................................................................................................................4-138