5
"Parameters" Operating Area 03.04
5.3 Tool mana
ement
5
Ó Siemens AG, 2004. All rights reserved
5-196 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Horizontal softkeys
Magazine
list
The first or most recently displayed magazine is shown in the
"Magazine list" together with all the tools which have been loaded.
You can access the next magazine by pressing the corresponding
vertical softkey.
Tool
list
All tools which are stored as a set of data on the NC are displayed
(irrespective of whether they have been assigned to a magazine
location).
Load
A magazine location is assigned to the tool.
Unload
The tool is deleted from the current magazine location.
Relocate
The tool is moved from the current magazine location to another
location.
Working
offset list
The cutting edges of active replacement tools are displayed. They are
sorted in order of ascending D numbers.
Further softkeys are displayed when you press the "Etc." key:
Tool
catalog
You can create new tool master data ("ideal" tools) and modify the
existing data.
Tool
cabinet
You can create new tool offset data and tool operating data ("real"
tools) and modify the existing data.
Trans-
formation
This softkey allows you to display the tool data as transformed data
(adapter data are calculated) or non-transformed data.
This conversion feature is only available in the magazine list display.
The data are always displayed as non-transformed data in the tool list
and as transformed data in the working offset list.
Special feature: If you display transformed data and want to create a new tool in the
magazine list (loading mode), the transformed data display is
activated exclusively for input of this data block.
To Next Page
Loading...
Need help?
General
