7
03.04 "Services" Operating Area
7.5 O
eration
7
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 7-385
You have marked the data that you wish to save/archive.
Select the target area (see title in window):
RS-232
· RS-232 interface (programming device) (1st RS-232 interface)
The system prompts you to start the data receiving device.
PG
· RS-232 interface (programming device) (2nd RS-232 interface)
The system prompts you to start the data receiving device.
Diskette
· Diskette drive: The diskette contents are displayed.
Enter the name of the new archive file.
Archives
· The contents of the "Archives" directory on the hard disk are
displayed.
Enter the name of the new archive file.
NC card
· The contents of the archives directory on the NC card are
displayed.
Enter the name of the new archive file.
Start
When exporting data from diskette/archive, press the softkey "Start",
otherwise the control is ready to receive immediately.
The data transfer is initiated. The vertical softkey bar changes. The
softkey labeling of the target area changes to "Stop". To abort data
transmission, press the relevant softkey again.
Other information
Archives to be stored on diskette need not fit completely on a single
diskette. Distribution of the archive over several diskettes is
supported.
The two RS-232 interfaces (RS-232 and PG) cannot be active
simultaneously.
Note:
When archiving workpieces that contain job lists of the same name, in
the case of m:n you are asked whether the job lists to be unloaded
are to be executed. You can terminate the action with "Abort",
otherwise all joblists are executed and archiving is then started.
To Next Page
Loading...
Need help?
General
