Siemens SINUMERIK 810D User Manual

2
Operator Components/Sequence of Operations 03.04
2.6 General se
q
uence of o
p
e
r
ation
2
Ó Siemens AG, 2004. All rights reserved
2-60 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Cursor block:
Use the "Direction keys" to position the cursor in the text.
You can page up and down using the "Page" keys.
The character on which the cursor is positioned is deleted.
Press the "Delete" key to delete the character to the left of the cursor.
Press the "Input" key to end a block. "L
F
" ("Line Feed") is
automatically generated.
Vertical softkeys
Over-
write
Overwrite
The softkey toggles between insert and overwrite modes.
Mark
block
Mark block
When you press this softkey, the vertical softkey bar changes. The
softkey marks the beginning of a block.
Now position the cursor at the end of the block.
The block is selected automatically.
Copy
block
The softkey copies the selected block into the buffer.
If a line which was generated by a support function is selected, the
complete support block is copied.
It remains stored in the buffer even if another part program
is selected.
Delete
block
The selected block is deleted.
If a line which was generated by a support function is selected, the
complete support block is deleted.
Mark
block
Selection mode is canceled when you select "Mark block".
Paste
block
Paste block
The softkey pastes the cut or copied block from the buffer into the text
in front of the cursor position.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English