0
03.04 Preface
Structure of manual
0
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition ix
The following notes used in the documentation are of special
significance:
Notes
This symbol appears in this documentation whenever it is necessary to
draw your attention to an important item of information.
In this documentation, you will find this symbol with a reference to an
ordering option. The described function can only run if the control
contains the designated option.
Warnings
The following warnings with varying degrees of severity appear in this
document.
Danger
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury or in substantial property damage.
Warning
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury or in substantial property damage.
Caution
Used with the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in minor or moderate injury
or in property damage.
Caution
Used without safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
Notice
Used without the safety alert symbol indicates a potential situation
which, if not avoided, may result in an undesirable result or state.
References
This symbol appears whenever specific information can be found in
other documentation.
complete list of available literature is included in the Appendix of this
Operator's Guide.
To Next Page
Loading...
