6 Assi
nin
Parameters to the Control and the PLC Pro
ram
6
03.96
6.4 Machine data masking filter (SW 4.2 and higher)
6-94
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
S Select all softkey
The checkboxes of the groups are activated.
The softkey does not affect the checkboxes of:
– Filter active
– Expert mode
– Index from to
– All others
S Deselect all softkey
The checkboxes of the groups are deactivated.
The softkey does not affect the checkboxes of:
– Filter active
– Expert mode
– Index from to
– All others
S Cancel softkey
– Return to the machine data display.
– The old filter settings are retained.
– Any changes are lost.
S OK softkey
– Changed filter settings are stored.
– The machine data display is reconstructed.
– The input field is positioned on the current MD again. If the MD has
been masked the field is positioned on the first MD.
The “expert mode” setting is intended to simplify initial start-up.
Intended procedure:
S Activate all filters (check).
S Activate Mask filters active (check).
S Deactivate expert mode (do not check).
S Only the machine data required for performing the basic functions are dis-
played (e.g. proportional gain, reset time, filter).
Data such as machine data for adaptation, reference model, etc. are not
displayed.
If all the machine data of an area are masked by the filter setting, the following
message appears when you select this area:
“With the current access rights and the current filter setting no machine data can
be displayed.”
After acknowledgment with the OK softkey an empty machine data window ap-
pears.
Vertical softkeys
Expert mode
Masking all
machine
data
08.97
To Next Page
Loading...
Need help?
General
