12/2008 3 Setting up functions
3.4 Fault services
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
3-103
Field Content Type
Number of lines The number in the display indicates
the number of lines per screen that
can be shown in this menu. You can
select up to 200 lines. A scroll bar will
then be displayed on the screen.
DISPLAY
SELECTION
Name Names of the control monitors DISPLAY
Memory requirements
(single monitor)
Used memory requirement of monitor
for:
• PLC trigger configurations
• PLC trace configurations
• PLC data
DISPLAY
Performance
(single monitor)
Currently used PLC performance. DISPLAY
Clock icon
(single monitor)
Display indicating whether the control
monitor has triggers that are
independent of the common start
date:
No display: No
Faded display: Yes, at least one
Normal display: Yes, all
DISPLAY
Single monitor status
(activation state)
Monitor runs on the machine or is
inactive.
DISPLAY
Synchronization status
(single monitor)
An exclamation point indicates that
the configuration currently stored is
not yet effective on the machine.
DISPLAY
Note
The PLC performance index allows you to define how much performance may be
used for the ePS PLC trigger. Each ePS PLC trigger uses a certain number of
performance points. In this way you can control to what extent the PLC may be
occupied by the ePS PLC trigger.
The PLC performance index can be defined on an individual basis, since the
amount of memory and the cycle time guaranteed for ePS Network Services may
vary depending on the performance of the control and the processes executed on
it.
Fig. 3-18: Exchanging addresses in notifications
To Next Page
Loading...
