7 Establishing a connection and diagnostics 12/2008
7.4 Configuring 1:N connections
© Siemens AG 2008 All Rights Reserved
7-260 ePS Network Services, Function Manual (FH) - Release 12/2008
7.4 Configuring 1:N connections
Configuring connections
Every NCU of a 1:N connection can be selected via a configuration tool and then
like a "standard machine" connected to an ePS database machine.
The configuration tool is called up automatically during the ePS client installation if
a 1:N configuration is detected by ePS.
After installation, one instance of the Machine Handler service is started for each
NCU selected.
Note
Every NCU selected must be connected to a separate database machine.
Fig. 7-26: 1:N configuration
To Next Page
Loading...
