12/2008 3 Setting up functions
3.4 Fault services
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
3-133
Notice
PLC counters cannot be used as ePS Network Services counters! It is not
possible to correct this configuration (counters). Instead, the configuration must
be deleted in its entirety and re-entered.
Since it is not possible to use the endless counter function of the PLC, when a
smaller new value is read, ePS Network Services calculates this as an offset to
the old value.
Fig. 3-34: Selection: Variable monitor counter
Field Content Type
Name Designation for the new trigger DISPLAY
INPUT
(Max. 40 charac-
ters; any character
permissible)
Add Add the selection of all possible
variable monitor variables for which a
trigger can be initiated.
ACTION
Selection The variable can be marked for use
once per trigger. Any number of
variables can be selected.
SELECTION
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance (see also: Sub-section 6.1.3 "Machines" Æ Master data,
and general description of triggers):
• If a label has been set and a start date, which has not yet been reached, has
been configured in the master data, the trigger will not be initiated.
• If the date has been reached or is in the past, the trigger will be initiated
according to the conditions set for it.
To Next Page
Loading...
