12/2008 3 Setting up functions
3.6 Copying
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
3-159
Field Content Type
Progress The copying process can take several
hours to complete if a large number of
machines has been selected as the
target. The progress bar shows an
estimation of the completed copying
process as a percentage value.
DISPLAY
Already copied Data is copied to the machines in
sequential order. All configurations
included in the selection are always
copied in their entirety one after the
other to each machine. This makes it
possible to indicate how many machines
already have all complete copies.
DISPLAY
To be copied The number of copies remaining is
displayed as the difference to the
'already copied' machines.
DISPLAY
Error If one or more errors occur during
copying, the error display is incremented
by one for each machine.
Information about the errors is displayed
separately.
Errors are usually caused by an
unsuitable selection of the source and
target machines (number of axes,
SIMATIC/SINUMERIK, etc.).
Irrespective of any errors that occur,
everything that is technically and
logically appropriate and correct is
copied correctly.
DISPLAY
Copied function
settings
All configurations selected for copying
are listed, just as in the selection, in a
window with a scroll bar.
DISPLAY
Target machines
…from…
… Machine ID
All selected target machines are listed.
DISPLAY
... Instructions Specific information about the copying
process is displayed to provide
instructions for manual editing of the
copied configurations or repetition with
other settings.
DISPLAY
… Status The current status of the copying
process is OK after complete, correct
execution. If an error occurred, this
remains indicated in the status.
DISPLAY
To Next Page
Loading...
