4 Organizational tasks 12/2008
4.1 Maintenance
© Siemens AG 2008 All Rights Reserved
4-176 ePS Network Services, Function Manual (FH) - Release 12/2008
Field Content Type
Master data Display your own data from the machine
master data. Where a job is concerned,
this may vary depending on the view
used for visualization: i.e. whether it is
viewed from the perspective of any
given partner, or, in the case of the
maintenance job list, your own point of
view.
DISPLAY
Job no., job desig-
nation, date, due
status
Unique, consecutive numbers for
maintenance jobs, which are
automatically generated by the system
in order to avoid misunderstandings in
communication
Designation of the maintenance
schedule, which the user has allocated
during configuration
Execution time for the maintenance job,
calculated by the system according to
the basic settings configured by the user
DISPLAY
Status Indicates the status of the job. The
status can be changed by the user at
this point.
Opening the job should indicate that the
maintenance procedures required in the
job have already been carried out.
Closing the maintenance job
corresponds to acknowledging it; here it
can be determined whether the
maintenance procedures were
performed successfully.
Important:
Even when the display has a particular
status, it is not actually set to this. In
each case, the status must be
confirmed with "OK" in order for it to
take effect and for the display to be set
to this. This can be monitored by calling
the maintenance job again.
SELECTION
Authors Here, the system automatically enters
the user logged onto ePS Network
Services who has most recently opened
the maintenance job on the machine
operator panel.
No display
Responsible org. Not displayed, since the responsible
organization would never inadvertently
look for the job on the machine
No display
Work instruction Description of the maintenance
procedures to be performed. This field
displays the work instructions for the
person performing maintenance.
DISPLAY
To Next Page
Loading...
