12/2008 5 Statistics/export
5.1 Multi-machine views
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
5-201
Displaying measurement series
In order to display measurement series in a diagram, the machine operator must
select the required characteristic from the table. The system will then generate a
diagram showing the progress in time of the selected characteristic for each of the
measurement series considered in the comparative display. There are various
functions available for changing the diagram or displaying detailed information.
Function Description
Machines In the "Machines" table, all measurement series
considered in the comparative function will be listed
according to machines. Individual measurement series
can be excluded from being displayed in the diagram or
included again.
Parameters The table shows the characteristics that are calculated for
the examined type of measurement series. For displaying
in the diagram, a characteristic needs to be selected.
Parameters The pull-down "Parameter" table shows the parameters of
the measurement being performed. Parameters that are
not identical in all measurement series will be marked.
Click the "Open" icon in the table to display a detailed
view of the parameters for each individual measurement
series.
Supplementary
conditions
The pull-down "Supplementary conditions" table shows
the supplementary conditions of the measurement being
performed. Supplementary conditions that are not
identical in all measurement series will be marked. Click
the "Open" icon in the table to display a detailed view of
the supplementary conditions for each individual
measurement series.
Time series This function displays the progression over time of the
selected characteristic within the defined period.
Machine series This function displays the selected characteristic from the
compared measurement series at a defined point in time.
It is displayed as a bar chart. The ordinate at the left-hand
side indicates the relative deviation from the average
value of the examined characteristics values. The right-
hand ordinate indicates the absolute value.
Time frame The time frame to be examined as a time series in the
display can be adjusted. You can select certain defined
periods or a period limited by two markings in the
displayed diagram.
Markings In the display as time series, two markings can be set by
double-clicking. These markings indicate the individual
characteristic values at this point in time and serve to
define a time frame or a point in time.
Defining time In the display as machine series, the reference point can
be defined. You can enter the point in time explicitly or
use one of the two markings.
To Next Page
Loading...
