2 Maschine information 12/2008
2.2 Variable monitors - Measurements and measurement series
© Siemens AG 2008 All Rights Reserved
2-42 ePS Network Services, Function Manual (FH) - Release 12/2008
Where individual measurement diagrams are concerned, the "Actions" menu and
context menu have the same options:
Entries menu
Parameters Shows the pop-up window with the list of measurement
parameters. The same pop-up window can be opened
from the context of the time series.
Supplementary condi-
tions
Shows the pop-up window with the list of measurement
parameters.
Comment Pop-up with measurement comment
Scaling Setting for the diagram scale (for the equability test
only). In the case of the diagrams for the circularity test
and universal axis test, the "Actions" menu does not
contain "Scaling".
Scaling for the equability test
Fig. 2-22: Scaling for the equability test
"Display" menu
This menu is only available for the individual measurement diagram of the
equability test.
Entries menu
All without ramps Displays the entire measuring range, but without
the acceleration ramps
All with ramps Displays the entire measuring range, including
the acceleration ramps
Between the markings Adjusts the zoom factor of the diagram at the
area between the markings. This function
assumes that both of the markings have been
set.
Navigating to previous/next measurement
The two buttons for this function can be used to navigate to the previous or next
measurement of the measurement series in question.
To Next Page
Loading...
