Mounting
8.12 Mounting 22.5 mm/17.5 mm devices with device connectors on the wall
3SK1 safety relays
144 Manual, 04/2013, A5E02526190021A/RS-AA/01
8.12 Mounting 22.5 mm/17.5 mm devices with device connectors on the
wall
Requirements
Please note the following requirements for mounting on a level surface:
● Please observe the information about the mounting position in the chapter "General
technical data (Page 193)".
● Two properl
y executed drill holes (per device connector) with thread or plug on the level
surface.
For details of the distances between the drilled holes, please refer to the relevant
dimension drawings in the chapter "Dimension drawings 3SK1 device connectors
(Page 251)".
● Two screws (
per device connector) to fit the holes M4 x12 in accordance with DIN 784.
● Device connector
Please refer to the accessories list for the relevant order number in the chapter
"Accessories (Page 257)".
To Next Page
Loading...
