SITRANS FM100
A5E48762204-AA page 19
9.3.1.2 Numerical value input
When setting parameters with a numerical value, the assigned unit is always
displayed below the input field in square brackets in the input function. The
maximum size and the number of decimal places are fixed and cannot be
changed. After calling the input function, first the left, outer digit is displayed in
orange. This position can now be adjusted either with the keys in the
value from 0 to 9. By pressing the key , the entry point moves to the right and
the next digit can be changed. By pressing the key , the editing point can be
moved to the left again. If the editing point is on the far right, the set value is
saved by pressing the key again and switched to the higher-level menu
function.
10. Device configuration
10.1 Sequence of device parameterization
The flowmeter FM100 is pre-configured in factory. Changing the parameters
"Measuring range" and "Sensor constant" or "K factor" is therefore not permitted.
The adjustment of these parameters is only possible on the part of Siemens -
factory.
In the event of subsequent changes to volume or throughput units, the dependent
parameters are converted and adjusted accordingly. However, the limit
parameters of the switching outputs must always be checked and adjusted
manually when adjusting volume or throughput units - these are not automatically
converted.
An accidental change of the parameterization can be revised by the function
"Reset factory setting" in the menu Userservice / Reset.
10.2 Language
In this menu item the menu language can be changed in English, German,
French or Spanish (standard: English).
Parameter table language
level
para-
meter
para-
meter
para-
meter
range /
value list
value LPM
value
GPM
Selects English as the
menu language
Selects German as the
menu language
Selects French as the
menu language
Selects Spanish as the
menu language
To Next Page
Loading...
