SITRANS FM100
A5E48762204-AA page 3
2. Note
Please read these operating instructions before unpacking and putting the unit
into operation. Follow the instructions precisely as described herein.
The devices are only to be used, maintained and serviced by persons familiar
with these operating instructions and in accordance with local regulations
applying to Health & Safety and prevention of accidents.
When used in machines, the measuring unit should be used only when the
machines fulfil the EC-machine guidelines.
as per PED 2014/68/EU
In acc. with Article 4 Paragraph (3), "Sound Engineering Practice", of the PED
2014/68/EU no CE mark.
Diagram 8, Pipe, Group 1 dangerous fluids
2.1 Overview of the device functionality
Depending on the installed device firmware, the FM100 device may have
different functionalities. The functional extensions are shown in the
following table.
Available from firmware version
Simulation function
User function keys
Analogue output 2-10 V
DC
Analogue output behavior acc. to NAMUR NE43
REV180514
REV190320
Additional flow units L/s and mL/s
The installed software version is displayed after starting the device below the
manufacturer logo in the form REVxxxxxx for approx. 2 sec.
To Next Page
Loading...
