Siemens SITRANS LR150 - Page 36

Setup with the integrated HMI
7.2Structure and views of the display
Display symbols
INFO field Symbol Meaning
LP
Device is write protected via parameter " User PIN".
Co Loop test in operation
EDIT When the symbol flashes, you can edit the parameter.
INFO Diagnostic message. The ID next to the INFO symbol is used
to identify the diagnostic message.
In the following, the different display views are shown and described.
Note
The display will return to measurement view after tenminutes of inactivity.
Measured value view
The measured value view shows the current measured values of the device as well
as status and diagnostic messages. Process value name and unit are displayed
alternately.
1
Process value name
2
Process value unit
3
Process value If the process value is too large to be shown on the display (value has more than 5
digits), hashes "#####" will be shown instead.
4
Process value number
5
Diagnosis symbol
Figure7.3 Measured value view
The following measured value views are offered:
Setting Description
P1 LEVEL Level
P2 SPACE Space
P3 DIST Distance
P4
a
VOL Volume
P5
b
VFLOW Volume flow
P6 LOOPC Loop current
P7 PERCENT Percent
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155
27