Siemens ST750 - Page 24

Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification
Error! Unknown document
property name.
Page
24 of 73
Version 008
Status
Released
Last Editor Nathan Fearnhead
Date
16/06/2017
Document Name Configuration Control
Document No.
667/CC/32750/000
Copyright © Mobility 2017. All Rights Reserved. Mobility is a division of Siemens Plc
Gasp Dial Battery, within the Gemini Power Supply Unit, is orientated correctly; the battery
terminal must be facing up. If the unit is to be mounted in such a way that the battery terminals
are not facing up then it is necessary to implement certain modifications to ensure that the battery
is not operating upside down. Please refer to document 667/HB/32600/000 for the necessary
modifications.
On those occasions when more than four Detector Cards are required, an 11” Swing Frame
should be specified. The ST750ELV can support up to a maximum of eight Detector Cards, and
therefore two Intelligent Detector Backplanes. To mount the Intelligent Detector Backplanes, the
11” Swing Frame must be provided with at least one 11” Detector Rack Kit. Please refer to
Figure 16 Figure 17,Figure 16
Figure 17 and Figure 18. To specify this option order the items detailed
in Figure 18. Please note if a Gemini
2
unit is to be specified an additional 11” Rack Assembly kit
will be required and fitted in the secondary position, please refer to paragraphs 3.9. If a
Freestanding O.T.U is to be fitted the 11” Detector Rack Assembly Kit, containing the Detector
Cards should be fitted in the secondary position. Please refer to paragraph 3.9.
Figure 16 Figure 17
11” Rack Assembly in the Primary Position
Figure 18
Position
for second
Intelligent
Detector
Backplane
11” Detector
Rack Kit
Mounted in
primary
position of
11” Detector
Swing Frame
Please
note the
SLD4
Detector
PCB is a
direct
replaceme
nt for the
ST4S
shown