Siemens ULTRAMAT 6 Series - Qualified Personnel

This device was designed to ensure safe isolation of the primary and secondary circuits. Low
voltages that are connected must therefore also be generated with safe isolation.
WARNING
Dangerous contact voltage
After removing the housing or protection against direct contact or after opening the system
cabinet, certain parts of this device/system will be exposed that can carry hazardous voltage.
Therefore, only appropriately quali󹪝ed persons are permitted to perform work within this
device. These persons must be thoroughly familiar with all sources of danger and service
activities in accordance with these operating instructions.
Note
Observe the environmental conditions for the rack unit and bench-top unit
Ensure compliance with the environmental conditions listed in the technical speci󹪝cations.
• During operation
• In the event of maintenance
Note
Environmental conditions for bench-top unit in accordance with IEC61010-1-2010
According to IEC 61010-1-2010, the bench-top unit may only be used indoors.
1.6 Quali󹪝ed Personnel
Quali󹪝ed personnel are individuals who are familiar with the installation, mounting,
commissioning, and operation of the product. These people have the following quali󹪝cations:
• They are authorized, trained or instructed in operating and maintaining devices and systems
according to the safety regulations for electrical circuits, high pressures and aggressive as
well as hazardous media.
• For explosion-proof devices: They are authorized, trained, or instructed in carrying out work
on electrical circuits for hazardous systems.
• They are trained or instructed in the maintenance and use of appropriate safety equipment
according to the safety regulations.
Introduction
1.6Quali󹪝ed Personnel
Series 6 and ULTRAMAT 23
10 Compact Operating Instructions, 01/2024, A5E45779144002-AB