Siemens ULTRAMAT 6 Series - Conformity with European Directives

1.7 Warranty conditions
We expressly point out that the product quality is exclusively and conclusively described in the
sales contract. The content of this product documentation is neither a part of a previous or
existing agreement, promise or legal relationship, nor is it intended to modify these. All
obligations on the part of Siemens AG are contained in the respective sales contract, which also
contains the complete and solely applicable liability provisions. The provisions de󹪝ned in the
sales contract for the responsibility for defects are neither extended nor limited by the remarks
in this document.
1.8 Delivery information
The respective scope of delivery is listed on the shipping documents in accordance with the valid
sales contract. These are enclosed with the delivery.
When opening the packaging, please observe the corresponding information on the
packaging material. Check the delivery for completeness and undamaged condition. In
particular, the Order No. on the labels, if present, must be compared with the ordering data.
If possible, please keep the packaging material since you can reuse it for return deliveries if
necessary.
1.9 Standards and regulations
As far as possible, the harmonized European standards have been applied to the speci󹪝cation
and production of this device. If no harmonized European standards have been referred to, the
standards and regulations for the Federal Republic of Germany are valid.
When this product is used beyond the scope of these standards and regulations, the
standards and regulations applicable in the operating company's country must be observed.
As per CSA, the ULTRAMAT23 is classi󹪝ed as C225206 and C225286 and certi󹪝ed according
to CSA accreditation to ISO/IEC17065 by the "Standards Council of Canada (SCC)". The
certi󹪝cate is valid for the versions with 120V/60Hz and 230V/60Hz.
1.10 Conformity with European directives
The product described in this document complies with the relevant harmonisation laws and its
amendments of the European Union.
Electromagnetic com‐
patibility EMC
2014/30/EU
Directive of the European Parliament and of the Council on the har‐
monisation of the laws of the Member States relating to electromag‐
netic compatibility
Explosion protection
directive
ATEX 2014/34/EU
Directive of the European Parliament and of the Council on the har‐
monisation of the laws of the Member States relating to equipment
and protective systems intended for use in potentially explosive at‐
mospheres
Introduction
1.10Conformity with European directives
Series 6 and ULTRAMAT 23
Compact Operating Instructions, 01/2024, A5E45779144002-AB 11