Siemens ULTRAMAT 6 Series - General Information

Table 1-2 Rack-mounted analyzers of Series 6 approved for operation in hazardous areas
Certi󹪝cate Ex type of protection Device MLFB no.
TÜV 02 ATEX 1873 X II 2/3 G Ex ec nC IIC T4 Gb/Gc CALOMAT 6E 7MB252x-xxx0x-xABx-Z xxx
FM 3018862
FM16US0375X
NI/ CL I / DIV2 / ABCD / T4, Ta= 45°C
IP20
Class I / Zone 2/IIC/T4, Ta=45°C IP20
CALOMAT 6E 7MB252x-xxx0x-xADx-Z xxx
CSA 1526660 (CAN/US) Class I, DIV 2, ABCD, T4, Ta= 45°C
IP20
Class I, Zone 2 Ex nA IIC T4, Ta=45°C
IP20
CALOMAT 6E 7MB252x-xxx0x-xADx-Z xxx
FM3016050
FM16US0376X
NI/ CL I / DIV2 / ABCD / T4, Ta= 45°C
IP20
Class I / Zone 2/IIC/T4, Ta=45°C IP20
ULTRAMAT 6E OXYMAT
6E
7MB212x-xxxx0-xxxx-Z E20
7MB202x-xxxx0-xxxx-Z E20
CSA 1526657 (CAN/US) Class I, DIV 2, ABCD, T4, Ta= 45°C
IP20
Class I, Zone 2 Ex nA IIC T4, Ta=45°C
IP20
ULTRAMAT 6E OXYMAT
6E
7MB212x-xxxx0-xxxx-Z E20
7MB202x-xxxx0-xxxx-Z E20
Figure1-4 Example of additional label FM/CSA series 6
1.3 General information
This device left the factory in a safe and proper condition and has been tested. In order to
maintain this condition and to ensure safe operation, it should only be used in the manner
described by the manufacturer. Furthermore, proper transportation, storage, installation,
operation and maintenance of the device are vital for ensuring correct and safe operation.
This manual contains the information required for the intended use of the described product.
It is addressed to technically quali󹪝ed personnel who are specially trained or who have the
relevant knowledge of automation technology (measuring and control systems).
Knowledge and technically correct implementation of the safety notes and warnings
contained in this manual are required for safe installation and commissioning, as well as
for safety during the operation and maintenance of the described product. Only quali󹪝ed
Introduction
1.3General information
Series 6 and ULTRAMAT 23
8 Compact Operating Instructions, 01/2024, A5E45779144002-AB