Siemens ULTRAMAT 6 Series - Analyzers in Hazardous Areas

WARNING
Insu󹪟cient ventilation
The device may overheat or start burning in the case of insu󹪟cient ventilation.
• Ensure su󹪟cient ventilation between the devices when installing in control cabinets. The
heat sinks at the rear must remain free for air circulation.
• Make sure during operation that the permissible ambient temperature range is always
observed (seeTechnical speci󹪝cations (Page51)).
CAUTION
Strong vibrations
Strong vibrations could loosen connections or damage sensors, resulting in free passage of the
sample gas into the environment.
Even weaker vibrations in󹪞uence the result!
The analyzer must therefore only be used at a location which is free of vibration.
Please observe the data in the Technical speci󹪝cations.
3.3 Analyzers in hazardous areas
DANGER
Explosion hazard
If a 󹪞ammable or ignitable atmosphere exists, plugs must never be disconnected or lamps/
fuses replaced when the analyzer is supplied with power.
Assembly/installation
3.3Analyzers in hazardous areas
Series 6 and ULTRAMAT 23
26 Compact Operating Instructions, 01/2024, A5E45779144002-AB