Siemens ULTRAMAT 6 Series - Page 6












8/75$0$7
30%$$&3
61&
$&9_+]_9$
0&2
012
0&2
6LHPHQV$*'(.DUOVUXKH
0DGHLQ)UDQFH
YSP
YSP

6,(0(16
0
0DQDXO(1$(
1 Data matrix code
2 CSA conformity mark (only for 120V/60Hz and 230V/60Hz)
3 CE conformity symbol
4 Name and address of manufacturer
5 Designation of origin
6 Measuring range(s)
7 Auxiliary power supply
8 Serial number
9 Order No. (MLFB number) of the device
10 Device name
11 Compact operating instructions (safety information)
Figure1-1 ULTRAMAT 23 label (example)
These Operating Instructions also cover the rack-mounted versions of Series 6 (CALOMAT 6E and
ULTRAMAT23) approved for operation in hazardous areas.
It is essential that you also observe the respective "Special conditions" of the certi󹪝cates
referred to in the table.
These describe
• The 󹪝elds of application
• The requirements for operation in hazardous areas
• Other precautionary measures which are important for operation.
The technical speci󹪝cations in these Operating Instructions may be di󹪜erent to those in the
associated Operating Instructions for the analyzers and additional equipment under some
circumstances. The technical speci󹪝cations listed in these Operating Instructions are valid in
such cases.
Introduction
1.2Product versions
Series 6 and ULTRAMAT 23
6 Compact Operating Instructions, 01/2024, A5E45779144002-AB