Siemens Vector Control - Page 318

Parameterizing Steps 05.2006
6SE7087-2JD60 Siemens AG
9-26 Operating Instructions SIMOVERT MASTERDRIVES
87654321
Setpoint source
MASTERDRIVES VCOP1S and fixed setpoints (P368=7)
- s71 -
KK0046 KK0045 KK0047 KK0048
KK0040
Act.FSetp
Active FSetp
r420
P443.B (40)
KK
Src Main Setpoint
P486.B (40)
KK
Src T setpoint
0 1 0 0 0 1 0 1 0 1 1 0 0 1 1 1
FSetp
Bit 3
P418.B
FSetp
Bit 2
P417.B
0 0 0 0 0 0 0 1 0 0 1 0 0 0 1 1
KK0042 KK0041 KK0043 KK0044
(for T control)
Fixed setpoint1 P401.F Fixed setpoint2 P402.F Fixed setpoint3 P403.F Fixed setpoint4 P404.F Fixed setpoint5 P405.F Fixed setpoint6 P406.F Fixed setpoint7 P407.F Fixed setpoint8 P408.F
in % in Hz
Fixed setpoints
Sheet [290]
Terminal strip
Sheet [90]
If used as digital inputs, the parameters P651.B, P652.B, P653.B and P654.B must be set to 0! If used as digital outputs, B10 to B14 must not be wired.
*
)
from sheet [200] to sheet [180]
to sheet[316.1]
to sheet[320.1]
N
M
n959.89 = 4
If P366 = 2 P590 = B0012 P651 = B0000 P652 = B0000 P653 = B0107
/5 /4 /3 /2 /1
B0014
P653.1 (0)
B
B0012
P652.1 (104)
B
B0010
P651.1 (107)
B
M24
P24
-X101
B0104 B0107
Operation
0=fault
*
)
*
)
1=operation
No fault
*
)
P590 (14)
B
Src BICO DSet
See P049.4
FSetp
Bit 1
P581.B
FSetp
Bit 0
P580.B
(for T control) (for n/f control or v/f control)