05.2006 Parameterizing Steps
Siemens AG 6SE7087-2JD60
SIMOVERT MASTERDRIVES Operating Instructions 9-1
9 Parameterizing Steps
The chapter entitled "Parameterizing Steps" describes the parameter
assignments to be made for starting up SIMOVERT MASTERDRIVES:
In addition to this chapter, you should also refer to Chapter 3 (First
Start-Up) and Chapter 8 (Parameterization) in the operating
instructions.
The parameterizing steps are divided into different categories:
♦ Parameter reset to factory setting (9.1)
♦ Quick parameterization procedures (9.2)
♦ Detailed parameterization (9.4)
The factory setting is the defined initial state of all the parameters of a
unit. The units are delivered with this setting.
A detailed description is given in section 9.1.
The quick parameterization procedures can always be used when the
exact application conditions of the units are known and no tests with the
associated extensive parameter corrections are required.
The following quick parameterization procedures are described in
section 9.2:
1. Quick parameterization, P060 = 3
(Parameterizing with parameter modules)
2. Parameterizing with user settings
(Fixed settings or factory settings, P060 = 2)
3. Parameterizing with existing parameter files
(Download, P060 = 6)
Depending on the specific conditions prevailing in each case,
parameters can either be assigned in detail (see section 9.4) or with
one of the specified quick procedures.
By activating a fixed setting (P060 = 2) the parameters of the unit can
also be reset to the original values.
Parameter reset to
factory setting
Quick
parameterization
procedures
To Next Page
Loading...
Need help?
General
