Parameterizing Steps 05.2006
6SE7087-2JD60 Siemens AG
9-66 Operating Instructions SIMOVERT MASTERDRIVES
Only deviations from the standard setting (P114 = 0) are indicated:
P114 = 0 P114 = 1 P114 = 2 P114 = 3 P114 = 4 P114 = 5 P114 = 6 P114 = 7
P216=Smooth n/f(FWD)
0ms (n-ctrl.)
4ms (f-ctrl.)
4.8ms
(n-ctrl.)
P217=Slip Fail Corr'n. 0=off 2=on (n-ctrl) 2=on
P223=Smooth n/f(act)
4ms (n-ctrl.)
0ms (f-ctrl.)
100ms
P235=n/f-Reg Gain1 3.0 or 5.0 12.0 (n-ctrl.)
P236=n/f-Reg Gain2 3.0 or 5.0 12.0 (n-ctrl.)
P273=Smooth Isq(set) 6*P357 (T0) 3*P357
P240=n/f-Reg Tn 400ms 40ms (n-ctrl.)
P279=Torque (dynamic) 20.0% 80% (f-ctrl.)
P287=Smooth Vd(act) 9 0 0
P291=FSetp Flux(set) 100% 110%
P295=Efficiency Optim. 100%=off 99.9% 50%
P303=Smooth Flux(set) 10-20ms 60ms
100 (n-ctrl.)
500 (f-ctrl.)
P315=EMF Reg Gain Gain(n)
1.5*Gain(n)
(f-ctrl.)
1.5*Gain(n)
(f-ctrl.)
P339=ModSystRelease 0=All syst 3=only RZM 3=only RZM 3=only RZM 3=only RZM 3=only RZM
P344=ModDepthHeadrm 0.0% 3.0% 3.0% 30.0%
P536=n/f RegDyn(set) 50% 20%
100 (n-ctrl.)
50% (f-ctrl.)
200 (n-ctrl.)
100 (f-ctrl.)
200 (n-ctrl.)
50% (f-ctrl.)
25%
100 (n-ctrl.)
50% (f-ctrl.)
100% (n-ctrl.
RZM = Space vector modulation
The gain Kp of the speed controller (P235, P236) depends on the
inertia of the drive and has to be adapted if necessary.
Symmetrical optimum: P235 = 2 x P116 / P240
Kp = 2 x T
start-up
/ Tn
The start-up time is the time taken by the drive to accelerate to rated
speed when the rated torque is specified. This is determined during
automatic speed controller optimization.
To Next Page
Loading...
