■ 8
│
GB
│
IE SSMS 600 E6
NOTE
► Fill the bowl 8 only up to the 500 ml mark
when processing food
and only up to the 300 ml mark
when processing liquids.
■ Put the bowl lid 6 on the bowl 8. When doing so, make sure that the
blade 7 is correctly engaged in the bowl lid 6.
■ Fit the motor unit 4 into the mount on the bowl lid 6. Make sure that the
two opposing fixing pins on the motor unit 4 slide into the tracks provided
for this purpose in the mount. Otherwise, the motor unit 4 cannot be con-
nected to the fitting on the bowl lid 6.
NOTE
► If you want to store food in the bowl 8, you can use the lid 9. To do this,
carefully remove the bowl lid 6 and motor unit 4 and also the blade 7
if necessary.
Operation
WARNING! RISK OF INJURY!
► The food being processed must not be too hot! Splashing contents could
scald the user.
WARNING! RISK OF INJURY!
► The blade 7 is extremely sharp! Handle it with great care at all times.
Hand blender and whisk operation
NOTE
► Fill the measuring beaker w only up to the 300 ml mark with food/liquids.
Once you have assembled the appliance as required:
1) Insert the plug into the mains power socket.
2) Hold down the switch
2 to process the food at a normal speed. Turn
the speed regulator 1 towards “Max” to increase the speed. Turn the speed
regulator 1 towards “Min” to decrease the speed.
3) Hold down the turbo-switch 3 to process the food at a high speed. By
pressing the turbo-switch 3, the maximum processing speed is immediately
available to you.
4) Once you are done processing the food, simply release the pressed switch
2/3.
To Next Page
Loading...
