Unpacking and Installation 4
man-CH-PVF-C-V17-2 Minilab 17
Unpacking and Installation 4
4.1 Unpacking
Your new laboratory equipment has been closely
inspected before being shipped to your plant.
However, damage can occur en route, so it is
wise to inspect all equipment on arrival. Notify
both the carrier and Simpson Technologies of any
damage at once. Damage should be noted on
the shipper’s receipt before signing for receipt of
the shipment.
The Minilab, Model PVF-C, is shipped in one piece with detached
cables, fittings, and accessories. It is intended to be used as received;
the only additional assembly required is ensuring cable connections
and fitting connections. No lifting equipment is required for handling.
The Model PVF-C equipment weighs approximately 56 kg (123 lbs.).
Due to its bulky dimensions and tight fitting shipping crate, it is
recommended that two people remove the equipment from the crate.
Whenever positioning or relocating this instrument, two people should
be utilized. The approximate instrument dimensions are 830 mm (32.6
in.) x 400 mm (15.7 in.) x 250 mm (9.8 in.). Its shipping weight (in a
crate) is approximately 60.5 kg (133 lbs.).
ONLY authorized personnel may unload and install this
equipment. Two people may be required to unpack this
instrument due to the bulky dimensions and tight fitting
packing crate.
1. Remove any loose accessories/parts within the shipping crate and
place in a location away from any packaging material to ensure
that these items are not misplaced.
2. Carefully remove the testing equipment from the packaging crate
and place on stable bench.
To Next Page
Loading...
