6 Operating Instructions
32 Minilab man-CH-PVF-C-V17-2
6.1.2.10 Log Off
After logging in to make changes and take measurements, it is
recommended that the user logs out and leaves the password level. The
permission to make changes remains active for 5 minutes without a
logout. Without logging out, there is a possibility of important settings
being changed. Press the "Enter" button in order to log out.
6.1.3 Measurement Series
In addition to the use of letters, there are 99 measurement identification
numbers available (01-99) for Minilab operation. Measurement
identification allows operators to differentiate between users, sand types,
or any other differentiating factor desired.
For example, if more than one user operates the Minilab, each person
can be issued a number with the Measurement Range Description. This
number may later be seen in the protocol and identifies the operator and
their set of measurements.
Also, for different sand systems, each system could be issued a number.
Therefore, sand types can later be differentiated for specific
measurements.
To Next Page
Loading...
