Safety 2
man-CH-PVF-C-V17-2 Minilab 3
Safety 2
Before operating and/or performing maintenance or
repair on Simpson Technologies designed and/or
manufactured equipment, it is required that all
personnel have read and understood the entire
Operation Maintenance manual. If any questions
exist, you must contact your supervisor or Simpson
Technologies before taking further action.
If properly operated and maintained, you’re Simpson Technologies
supplied equipment can provide many years of dependable and safe
operation. Please follow all recommended safety, operating, and
maintenance instructions. Furthermore, the introduction of any non-
Simpson Technologies manufactured and/or approved parts to the
equipment may create a hazardous situation. Never alter the
equipment without prior consultation with Simpson Technologies.
DO NOT use this machine for purposes other than
that for which it is intended. Improper use could
result in death or serious injury.
2.1 Safety Signs and Labels
Simpson Technologies has incorporated the ANSI Z535.6/ISO 3864-
1-2 safety symbol only label format on all of its laboratory equipment.
The harmonized ANSI Z535.6 format became an established safety
label format since it not only fully meets the current ANSI Z535
standards, but also incorporates ISO 3864-2 symbols and hazard
severity panel and thus, can be used for both the U.S. and
international markets.
To Next Page
Loading...
