Chapter 8-22 CA34/44/54 Waypoint / route menu
Receive WPs and routes
7
Press [7] to enable reception of waypoints and routes from the plan-
ning program
The transmission of waypoints and routes can now be activated from
the PC program. The info window below will inform you of the
progress of the reception of data by keeping an eye on the counter.
When the counter stops, means that all the data from the PC plan-
ner has been collected. However, some PC programs may continue
to transmit the same data over and over again and will have to be
stopped by pressing [ENT].
Receive WPs and routes
Reception in progress
37 WPs received
5 routes received
Stop and save
ENT
ENT
Stop and save
- will stop collecting data (if not already finished) and start saving
the collected data.
Waypoints/routes transmitted to the CAXX are added to the WP/
route list. However, if two waypoint/route names are identical, the
latest transferred one will not be saved, even though position(s) may
be different. Routepoints will not be included in the WP list.
Saving the collected data can take anywhere from less than a second
and up to a few minutes, depending on the amount of data. If it takes
too long and you need the CAXX in a hurry, then press the [MENU]
key to Stop saving any more data - what has been saved until this
point will stay in the memory, the rest will be lost.
MENU
Stop saving
Under normal circumstances we assume the saving procedure is
allowed to finish and will indicate “Saving completed” in the info
window. You are now ready to:
MENU
Exit function and return to normal NMEA communication
To Next Page
Loading...
Need help?
General
