Simrad ES60 - REFERENCE MANUAL REV H User Manual

Getting started
29
857-160970 / Rev.H
Navigation interface
To link acoustical data with navigational data the ES60 must be
able to receive data provided by a GPS or another positioning
system. The Navigation Interface dialogue box is used to
define the parameters to achieve this.
Open the Install menu, choose the Navigation command to
open the Navigation Interface dialogue box.
Specify how the ES60 will receive navigational data. Since the
NMEA standard has been implemented, you only need to
choose between NMEA or ASCII.
If ZDA clock is available, the PC system clock can automatic be
synchronised with ZDA input. Then choose “Automatic Set
Clock”.
Click OK when you have made the setting.
Additional interfaces
Additional interfaces have been provided for other peripheral
systems.
• If you need to link recorded acoustical data with trawl
position data, choose the Trawl command on the Install
menu to specify the trawl position interface.
• If you need to connect your ES60 to a purse seine system,
choose the Purse seine command on the Install menu to
specify the purse seine system interface.
If you want to use a heave or a temperature sensor, choose the
Heave and Temperature commands on the Install menu to
specify these interfaces.
Related topics
→ Power on/off procedure, page 38
→ Display views, introduction, page 12
→ Frequency channels installation procedure, page 44
→ Transceiver Installation, page 117
→ Transceiver Settings, page 119
→ Environment, page 89
→ Navigation Interface, page 100
→ Heave Sensor, page 93
→ Temperature Sensor, page 116
→ Trawl Interface, page 122
→ Purse Seine, page 109

Simrad ES60 - REFERENCE MANUAL REV H Specifications

General

Brand	Simrad
Model	ES60 - REFERENCE MANUAL REV H
Category	Marine Equipment
Language	English